Heat pump or furnace? That is the first thing that matters when the heat quits in Tucson, AZ, because the two fail in completely different ways. Heat pumps tend to freeze up when defrost stops working, get stuck in cooling when a reversing valve fails, or quietly lean on the electric backup strips, at several times the normal operating cost, when the outdoor unit dies. Gas furnaces usually come down to the flame sensor: once oxide coats it, the burners light but the flame cannot be proven, so the board cuts the gas and locks out after three tries. After that, the usual suspects are cracked hot surface igniters, stuck pressure switches, clogged condensate traps on high-efficiency models, and blower motors at the end of their life.
Most of our service calls are for Furnace Repair. Start there if your system isn't running right.
When to Call for Heating Repair in Tucson
Spotting the early warning signs lets you act before the problem gets expensive. Keep an eye out for the following clues:
- Banging at startup caused by burners lighting late
- Short cycling every few minutes while the house stays cold
- Cold air, or no air at all, when the thermostat calls for heat
- Burning, musty, or rotten-egg odors when the heat runs
- An outdoor heat pump coil that stays iced over
- Cold rooms in one part of the house while others are comfortable
- Higher heating bills with less comfort to show for them
- Clicking and failed ignition attempts before the furnace gives up
Early Action Saves Money
What seems like a minor issue today can take out a compressor or heat exchanger tomorrow. Call (520) 614-1809 at the first sign of trouble.
